Zhone 3920Plus Bedienerhandbuch PDF herunterladen (Seite 71)

Status Branch

4-133920-A2-GH30-40 October 1998

Backup

The Status Backup function displays the configuration of the modem’s current operating line

facility and the configuration and condition of the inactive line.

NOTE

The modem’s rear panel has two line interface jacks: LEASE and

DIAL (see Figure 2-2 in Chapter 2). The jack labeled LEASE is the

APL primary interface and accepts either 2-wire or 4-wire APL. The

jack labeled DIAL is the backup interface and accepts either 2-wire

APL (Dual Lease Line) or Dial lines.

To access Backup from the Status branch, make the following selection:

Press the

key until Backup appears.

Status:

DTE Backup

Select Backup.

Status:Backup >

Line=Pri 4w APL

The configuration of the current operating line facility (either APL primary or backup) appears

(refer to Table 4-3).

Press the

key to display the next screen.

Status:Backup <

Bckup:2wAPL=Good

This screen displays the configuration and condition of the inactive line facility (either APL

primary or backup).

There are four condition codes, Good, Bad, ????, and ‘ ’ (blank).

Table 4-3 provides information about the Status Backup screens. The first column lists all

possible configurations for the modem’s currently active line. The second column lists all

possible configurations for the modem’s inactive lines. The third column provides information

about the inactive line condition.

XXXX represents the condition code of the inactive line.

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 353 354

Keine Kommentare

Zhone 3920Plus Bedienerhandbuch Seite 71