Zhone 3920Plus Bedienerhandbuch PDF herunterladen (Seite 150)

COMSPHERE 392xPlus Modems

5-74 October 1998 3920-A2-GH30-40

Table 5-14

(2 of 5)

Miscellaneous Configuration Options — Singleport Mode A

Access frm Remt: Enable

Nxt Enable Disable

Access from Remote. Determines if your modem’s DCP can be accessed by a remote modem via the VF line.

CAUTION: If this configuration option is disabled, the modem cannot be accessed by another modem.

Enable – Allows access from a remote modem.

Disable – Does not allow access from a remote modem.

NOTE: The remote modem must be a Model 3920Plus or Model 3921Plus modem.

The AT command is S-Register S55 = n, where n is 0 for Enable and 1 for Disable.

RemAccssPasswrd: 00000000

Nxt " 00000000

Remote Access Password. Allows the entry of a password for establishing control of a remote modem from the DCP of

a local modem. The same password must be used in both the local and remote modem.

CAUTION: A remote access password should be selected for security purposes.

NOTE: If the Access from Remote configuration option is set to Disable, the password has no effect.

The AT command equivalent is S-Registers S56 = n, S57 = x, S58 = y, and S59 = z, where n is the leftmost pair of

digits, x is the second pair of digits, y is the third pair of digits, and z is the rightmost pair (or fourth) pair of digits. For

example, if the remote access password is 12345678, then the value for S56 is 1 and 2, and the value for S59 is 7

and 8.

Dir#1_Callback: Disable

Nxt Disable Enable

Directory Location 1 Callback. This configuration option controls whether or not the modem’s single number callback

function is used.

Disable – Modem does not use the single number callback function.

Enable – Modem answers a call, disconnects, and dials the number stored in directory location 1.

NOTE: This function is disabled if dial access security is enabled.

The AT Command to Disable is S-Register S67 = 0.

The AT Command to Enable is S-Register S67 = 1.

Callback Delay: Disable

Nxt Disable 20sec 40sec 1min 2min 3min

This configuration option only appears if Dir#1 Callback is enabled.

Callback Delay. Determines the amount of time between disconnect confirmation and callback origination.

Disable – No time is specified. The default delay is 10 seconds.

20sec – 3min – The delay is set to the specified duration.

The AT command is S-Register S60 = n, where n is 0 for Disable, 1 for 20sec, 2 for 40sec, 3 for 1min, 4 for 2min, and

5 for 3min.

1 2 ... 145 146 147 148 149 150 151 152 153 154 155 ... 353 354

Keine Kommentare

Zhone 3920Plus Bedienerhandbuch Seite 150