Zhone 3920Plus Bedienerhandbuch PDF herunterladen (Seite 166)

COMSPHERE 392xPlus Modems

7-6 October 1998 3920-A2-GH30-40

The port field (xxxxx) displays the currently selected interface. Valid interface selections are

Port1, Port2, Port3, Port4, and depending on the set value of the Diagnostic Connection

configuration option, CC (NMS Control Channel), or DC (Diagnostic Channel). Refer to Diag

Connection configuration option in the Misc section of Chapter 5, Configure Branch.

Press the F1 key until the appropriate digital interface appears. Select the appropriate interface

by pressing the corresponding function key.

After selecting the desired interface, the message Command Complete appears on the bottom

line of the LCD and the selected interface appears in the xxxxx field.

To exit this function and remain in the Control branch, press the

key. To exit and return to

the Top-Level menu, press the

key.

NOTE

The Port 1 interface is the only display allowed on the 3921Plus

modem in Singleport mode, therefore the entire EIA LEDs branch is

masked.

Make Busy/Remove Make Busy

The Make Busy function forces the modem off-hook so it cannot answer a call. This is often

used with PBX systems to permit the busy out of a PBX port for rotary or hunt groups.

WARNING

To prevent violations of FCC and DOC regulations, this

function must only be used behind a user’s PBX.

To access Make Busy from the Control branch, make the following selections:

Control:

Make_Busy

Press the key until Make Busy appears. Select Make Busy.

Make Busy

Command Complete

The modem is now in a forced busy condition. Command Complete appears on the LCD.

1 2 ... 161 162 163 164 165 166 167 168 169 170 171 ... 353 354

Keine Kommentare

Zhone 3920Plus Bedienerhandbuch Seite 166