Zhone 3825Plus Betriebsanweisung

COMSPHERE3825Plus MODEMQUICK REFERENCEDocument No. 3825-A2-GL10-30

8AT COMMANDS (continued)Yn Long Space DisconnectY0 Disable.Y1 Enable.Zn Reset and Load ActiveZ0 Loads contents of Active (Saved) intoActive (Operatin

9AT COMMANDS (continued)&Sn DSR Control&S0 Forced On. Forces DSR signal ON.&S1 Standard RS232. Modem controls DSRsignal.&S2 Wink When

10AT COMMANDS (continued)\Nn Error Control Mode\N0 Buffer Mode. Modem does not use errorcontrol; DTE rate can differ from VF rate.\N1 Direct Mode.

11S-REGISTERSRegister Description Factory Setting Range S0 Auto-Answer Ring Number 1 0(Disable) or 1–255 rings S2 AT Escape Character 43(+) 0–127 A

12S-REGISTERS (continued)Register Description Factory Setting RangeS56 Remote Access Password 00 00–991st and 2nd digitsS57 Remote Access Password

13!Important Safety Instructions1. Read and follow all warning notices and instructions marked on the product orincluded in the manual.2. Slots and o

14Notices!WARNING:THIS EQUIPMENT HAS BEEN TESTED AND FOUND TO COMPLY WITH THE LIMITS FOR A CLASS BDIGITAL DEVICE, PURSUANT TO PART 15 OF THE FCC RULE

15United States – Notice to Users of the Telephone Network1. This equipment complies with Part 68 of the FCC rules. On the equipment is a labelthat c

169. The Telephone Consumer Protection Act of 1991 makes it unlawful for any personto use a computer or other electronic device to send any message v

17United KingdomRinger Equivalence NumberThe Ringer Equivalence Number (REN) is a customer guide indicating approximatelythe maximum number of items

Copyright E 2003 Paradyne Corporation.All rights reserved.Printed in U.S.A.NoticeThis publication is protected by federal copyright law. No part of th

18All European CountriesSafety NoticeFor pluggable equipment, the mains socket outlet shall be installed near the equipmentand be easily accessible.I

1COMSPHERE 3825Plus ModemQuick ReferenceDocument Number 3825-A2-GL10-30October 2003Product Documentation on the World Wide WebComplete documentation

2Customer-Supplied EquipmentThe following customer-supplied equipment is required to complete a datacommunications system using a 3825Plus modem:H A

3DTE ConnectionUse the following procedure to connect the RS-232-E cable from the modem to theDTE:" Procedure1. Make sure the modem’s rear panel

4AC Power Transformer ConnectionUse the following procedure to connect the modem to an ac power outlet:" Procedure1. Make sure the modem’s power

5To change a factory template, perform the following steps." Procedure1. Use the AT&F&W command to load the appropriate factory configur

6If these settings are not appropriate, then change them to a setting compatible withyour current application.The procedures for an AT recovery using

7AT COMMANDSBold text indicates Async Dial factory defaults.AT Attention Command Prefix/AutobaudRate. Indicates a command string hasstarted and deter