Zhone IMA CS-200 System Spezifikationen Seite 134
- Seite / 232
- Inhaltsverzeichnis
- FEHLERBEHEBUNG
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
7-2 E&M Ports
Model No.
Running Head
7.3 E&M port User Screens and Settings
7.3.1 E&M port Main Screen
You must configure the E&M port for operation after installing it in the system chassis. This
is done from the E&M Main port Screen, which is shown in Figure 7-1. To go to that screen,
highlight the desired port on the System Main Screen, then press <Enter>. The E&M port
Main Screen shows four columns of settings, one for each of the E&M ports.
Figure 7-1.Typical E&M port Main Screen
The bottom highlighted line of this screen shows various actions that you can perform from
this screen. You perform the desired action by pressing the associated uppercase letter key.
Table 7-1 on page 3 summarizes these actions. For example, after you configure the E&M port
ports, press “s” to save your settings.
- IMACS-200 1
- System Reference Guide 1
- Product Description 3
- Features in this Release 3
- System ports 3
- Technical support 5
- Service requirements 5
- Panel and Cover Removal 8
- Power Source 8
- Ordering Guide 8
- Available Cabling 9
- Model No 10
- Running Head 10
- Table of Contents 1 11
- Table of Contents 3 13
- Appendix B Error Messages 15
- Appendix C Glossary 15
- List of Figures 1 17
- List of Tables 1 19
- Chapter 1 21
- System Overview 21
- Introduction System Overview 22
- Chapter 2 23
- System Installation 23
- 2.2.2 Pre-Installation Tips 24
- 2.2.4 Installing the Chassis 25
- 2.3 Connector Types 27
- 2.4 Connector Pin-outs 29
- 2.4.4 Ethernet connections 32
- 2.4.5 Sub Rate Data Ports 32
- 2.4.6 Alarm Output Connector 33
- 2.5.5 Grounding requirements 35
- 2.5.7 DC power installation 36
- 2.5.8 AC power installation 37
- 2.5.9 Powering Up the System 37
- Chapter 3 39
- 3.3.1 System Boot 40
- 3.3.2 Logging Into the System 41
- 3.4 System Screens 43
- System Operation 3-7 45
- 3.5 Port Configuration 46
- System Operation 3-9 47
- 3.6 Reinitializing the System 48
- 3.7 Alarms 49
- 3.7.1 Alarm Screens 50
- 3.7.2 Alarm Filter Settings 51
- 3.7.3 Alarm Modifiers 52
- 3.7.4 Alarm Cutoff (ACO) 53
- 3.7.5 Alarm Handling 53
- 3.8 Cross-Connecting (XCON) 54
- 3.9 System Level Maintenance 54
- 3.9.2 Debugging the System 55
- 3.9.5 TFTP Backup for 1.x.x 56
- 3.9.6 TFTP Restore for 1.x.x 57
- 3.9.7 XMODEM Backup 58
- 3.9.8 XMODEM Restore 58
- 3.10 Time Slot Assignment 59
- 3.11 Assigning Time Slots 60
- System Operation 3-23 61
- 3.12 Circuit Names 62
- Renaming Circuits 63
- System Operation 3-27 65
- CIRCUIT ID 67
- WARNING! 68
- Figure 3-25.WAN Unit Options 69
- 3.14 Cross-Connect Actions 71
- 3.16 Power Supply Redundancy 73
- Chapter 4 75
- IMACS-200 General Features 75
- 4.3.1 SYS port Main Screen 76
- Table 4-2. User Access Table 77
- General Features 4-5 79
- WAN Provisioning 81
- WAN Alarms 81
- Access Provisioning 81
- 4.3.4 Other SYS port Settings 82
- 4.3.5 SYStem Ethernet Port 83
- General Features 4-11 85
- General Features 4-15 89
- RTT Decreased 91
- Connections Opened 91
- Connections Closed 91
- Connections Aborted 91
- Packets TX Aborted - RAM 91
- General Features 4-19 93
- 4.4.1 Equipment Requirements 94
- 4.4.2 Laptop Setup 95
- 4.4.3 Upgrade Preparation 96
- General Features 4-23 97
- General Features 4-25 99
- 4.6 SYS port Error Messages 101
- 4.7 SYS port Troubleshooting 101
- Chapter 5 103
- WAN ports 103
- 5.3.1 T1 Settings 104
- LINE CODE 105
- LINE LEN 105
- EER THRHD 107
- 5.3.2 Cross-Connect (XCON) 108
- 5.3.3 Performance Data 109
- WAN Ports 5-9 111
- 5.3.5 Test Screen 114
- WAN Ports 5-13 115
- 5.4 WAN port Error Messages 117
- 5.5 WAN port Troubleshooting 117
- 5.6 WAN port Specifications 118
- WAN Ports 5-17 119
- Chapter 6 121
- FXS Ports 121
- CAUTION! 123
- 6.3.2 Test Screen 125
- FXS Ports 6-7 127
- 6.4 FXS Error Messages 129
- 6.5 FXS port Troubleshooting 129
- 6.6 FXS port Specifications 131
- Chapter 7 133
- E&M Ports 133
- E&M Ports 7-5 137
- E&M Ports 7-7 139
- E&M Ports 7-9 141
- Standards Compatibility 141
- Chapter 8 143
- SRU Ports 143
- Sub Rate Data Ports 8-5 147
- Figure 8-3. Local Loopbacks 149
- 8.3 Test Screen 151
- Test Screen SRU Ports 152
- SRU Ports Test Screen 153
- 8.4 SRU port Error Messages 155
- 8.5 SRU port Troubleshooting 155
- 8.6 SRU port Specifications 157
- Chapter 9 159
- HSU Ports 159
- 9.2.1 HSU Port Cables 160
- 9.3.1 HSU Card Main Screen 160
- Tx CLOCK 163
- Tx CLOCK PLRTY 163
- Rx CLOCK PLRTY 163
- High Speed Data Ports 9-7 165
- 9.3.2 HSU Card Test Screen 166
- 9.4 HSU Card Error Messages 169
- 9.5 HSU Port Troubleshooting 169
- 9.6 HSU Port Specifications 169
- Chapter 10 171
- OHSU ports 171
- 10.2.2 OHSU port Cables 172
- 10.3.1 OHSU port Main Screen 172
- 10.4 OHSU port Specifications 175
- Chapter 11 177
- Alarm ports 177
- Alarm Ports 11-3 179
- Alarm Ports 11-5 181
- Chapter 12 183
- 12.3 User port Diagnostics 184
- 12.3.2 Voice Diagnostics 185
- 12.4.1 Circuit Diagnostics 186
- Diagnostics 6 189
- Diagnostics 5 189
- Diagnostics 7 189
- Diagnostics 8 189
- Diagnostics 9 189
- Appendix A 191
- Safety and EMC of WAN ports 193
- FXS ports 193
- A.3 Chassis Standards 195
- A.3.4 Equipment Handling 196
- A.3.6 Cable/Power Connections 197
- A.3.7 Mounting 197
- A.5 port Specifications 199
- A.6 FCC Requirements 200
- A.7 UK Requirements 201
- A.8 Year 2000 Compliance 201
- Appendix B 203
- Error Messages 203
- Error Messages B-3 205
- Error Messages B-5 207
- Error Messages B-7 209
- Error Messages B-9 211
- Glossary 213
- Glossary -3 215
- Glossary -5 217
- Glossary -7 219
- Glossary -9 221
- Glossary -11 223
- Glossary -13 225
- Glossary -15 227
- Glossary -17 229
- Glossary -19 231
Verwandte Produkte und Handbücher für Server Zhone IMA CS-200 System
Server Zhone IMA CS-200 System Spezifikationen
(302 Seiten)
(302 Seiten)
© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.060 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern