Zhone MIM-4T1 Betriebsanweisung PDF herunterladen (Seite 5)

MIM4-A2-GZ41-00 June 2005 5

Single T1 Connection

A single line connection may be established between a MIM-4T1 and Paradyne’s

T1 provider equipment (stand-alone or IP DSLAM module), regardless of loop

bonding capability.

Procedure

1. If a ferrite choke is supplied with your MIM:

— Open the ferrite choke.

— Make a loop at the end of your cable and close it in the ferrite choke.

Position the choke as close as possible to the RJ48C connector.

— Snap shut the ferrite choke.

2. Plug your T1 cable into one of the T1 RJ48C ports on the MIM-4T1. Any port

may be used.

3. Verify the connection: the T1 link LED on the front of the MIM will flash green

to indicate the connection is established and operational.

T1 RJ48C Pinouts

If you are using a shielded T1 cable for your network connection, it must be

grounded through pins 3, 6, 7, and 8.

PIN CONNECTION

1Rx Ring

2 Rx Tip

3 not used

4 Tx Ring

5 Tx Tip

6 not used

7 not used

8 not used

1 2 3 4 5 6 7 8 9 10

Keine Kommentare

Zhone MIM-4T1 Betriebsanweisung Seite 5