
SPEED-DSL 9.2
SPEED-DSL 9.2/22.10.2004 page 8
2 ADDITIONAL INFORMATION
2.1 LED Indications
LED
State Indication Additional Information
Power solid green unit is operational If the Power LED is not illuminated, it is
unlikely that the SPEED-DSL 9.2 is
receiving power and therefore none of the
LEDs will be illuminated.
pulsing
green
G.SHDSL
connection is
established and
active
Traffic is flowing.
solid green problematic
G.SHDSL
connection
A connection exists but there is indication
of a problem with the G.SHDSL line.
SDSL Link (Lnk)
Ports 1 - 4
no
illumination
no G.SHDSL
connection
See NOTE on following page.
flashing
amber
G.SHDSL activity The SPEED-DSL 9.2 is receiving data.
solid amber heavy Rx traffic The SPEED-DSL 9.2 is receiving large
amounts of data.
SDSL Data
Reception (Rx)
Ports 1 - 4
no
illumination
no activity A G.SHDSL link may exist but the SPEED-
DSL 9.2 is not receiving any data.
flashing
amber
G.SHDSL activity The SPEED-DSL 9.2 is transmitting data.
solid amber heavy Tx traffic The SPEED-DSL 9.2 is transmitting large
amounts of data.
SDSL Data
Transmission (Tx)
Ports 1 - 4
no
illumination
no activity A G.SHDSL link may exist but the SPEED-
DSL 9.2 is not transmitting any data.
solid green 100 Mbps Ethernet
connection is
established
If the Ethernet 100 LED is illuminated, the
Ethernet Lnk LED will also be illuminated.
See NOTE below.
100 Mbps
Ethernet Link
(100)
no
illumination
no 100 Mbps
Ethernet
connection
If the Ethernet 100 LED remains unlit but
the Ethernet Lnk LED is illuminated then a
connection has been established at 10
Mbps rather than 100 Mbps.
pulsing
amber
standard operation Traffic is flowing without any problems 10/100 Ethernet
Activity (Act)
solid amber heavy traffic A solid amber Ethernet Act LED can also
signify a lost G.SHDSL connection; see
NOTE below.
Kommentare zu diesen Handbüchern